Part and number
I am looking for a good condition one of these if anyone knows of one.
Otherwise any of you with an EPC would kindly find me a part number I would be very much obliged.
I do have an EPC but its still packed away in that elusive box :roll:
Give us a chance. May we have a photo showing a slightly wider area. It looks like part of a linkage to one of the pedals .Accelerator?
Anyway there's plenty of life left in that one :D
I don't have a partnumber but got this sent secondhand from Merv at the G-class centre.
That is if it is the bush for the throttle linkage on the bulkhead :oops:
Richard
Greeney,
I have replaced this part at some stage and looking at my notes I THINK that the part is either 123 300 00 40 or 460 300 02 40 I think that I had to check which one of this was applicable maybe for LH or RH drive. My spreadsheet is not that detailed.
I am not 100% positive that this is it because I bought quite a few parts at the same time. I don't think that it was very expensive though. Maybe AUS$30.
I hope that this is of some help.
John
Greeney,
PM' me the VIN of your truck and I shall look it up for you this evening in my EPC... I don't have connection at the moment!
Greeney,
I have replaced this part at some stage and looking at my notes I THINK that the part is either 123 300 00 40 or 460 300 02 40 I think that I had to check which one of this was applicable maybe for LH or RH drive. My spreadsheet is not that detailed.
I am not 100% positive that this is it because I bought quite a few parts at the same time. I don't think that it was very expensive though. Maybe AUS$30.
I hope that this is of some help.
John
True, not using any VIN filters, the parts listed in the EPC are those you mention. I am inclined to think that it must be part no. 460 300 02 40 being Greeney's a RHD but that's why I need his VIN.
part 214 is p/n 460 300 02 40 as stated above
Greeney, just to confirm that I checked the part with your VIN and is the one quoted by Roly. Cheers
YES silly me forgot to mention it is in fact the accelerator linkage where it changes direction. It actually looks better than it is :shock:
The centre 'bearing?' wobbles around by about 5mm all round